thanks to andy i now have an MC21 front end comming for my MC16. i,m also going to fit an MC18 swinging arm. what i,d like to know is, should i use a 17 or 18 inch rear wheel. i can find 18,s no problem. even a magtec from salobike, but i cannot find a 17 as yet.
should i use the MC16 or 18 shocker?
'21 shock is too long. I have a feeling either the '16 or '18 shock will work, as may an early (1987-8 RS250, if you want something a bit more special!
Jeff ive just asked about a price of the frame/swinging arm from a mc21,ifs its the right price you can have the frame/swinging arm shock and linkages from my other 18 for a small fee .
Download the plans on the Technical Resources page, and make up some MC18 F3 linkage plates. That will increase the ride-height by 25mm (1" for those Stateside!!) and stiffen the rising-rate.
Andy.
NSR-WORLD.COM
Last edited by Andy on Mon Jan 17, 2005 11:12 pm; edited 1 time in total
Andy wrote:'21 shock is too long. I have a feeling either the '16 or '18 shock will work, as may an early (1987-8 RS250, if you want something a bit more special!
Andy.
NSR-WORLD.COM
Just to add to that.... The RS250 shock will also transplant directly to and from any RG500 strangely enough as I run an RS250 Ohlins on mine although it's quite and experience setting it up on the road...
_________________ These aren't the droids you're looking for.
nsr.wayne wrote:Jeff ive just asked about a price of the frame/swinging arm from a mc21,ifs its the right price you can have the frame/swinging arm shock and linkages from my other 18 for a small fee .
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum