could anyone tell me a rough price as to what the full nf5 harness,cdi's flywheel etc fetch,cheers si
_________________
ive seen more tarts than mr kipling

Mine cost $675NZ plus $147 freight and agents fees. ($18US agents fee buys a lot of NZ rupees, plus freight inside japan, plus international freight)
Somewhere around 30000 japanese yen at the time off Yahoo Japan
Its only missing the reg/rect.

Gotta get my cases machined for it...

I got mine through Andy C off this forum.

Its an '88 or '89 F3 electrics, the one that has the NF5 CDI and NH3 RC valve controller...
_________________
The Chopster

Si, PM sent.
_________________
Rich
MC21 Track Bike / RS250 NF5 'Spencer', NX5 'Cadalora' & NXA 'Aoyama' / RS500 / Two Brothers Racing RC30

thanks fellas
_________________
ive seen more tarts than mr kipling

The NF5 and F3 (NH3) PGM-II's are not the same, there's also pre-PGM F3/RS options. They may be the same.

The NF5 and NH3 (F3) PGM-II are definately plug and play with the mk2 mc18 loom if you want to go part way.
Pre PGM F3(RS) and PGM-II|(any) RC valve servo motors are not swappable, you will kill the CDI.
_________________
Please do not PM me technical questions, if you can't find it on the Forum start a thread

fontyyy wrote:
Pre PGM F3(RS) and PGM-II|(any) RC valve servo motors are not swappable, you will kill the CDI.

They're not?... You will?
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

cheers fontyyy the mc18 loom and pgm-II sound the cheapest and less hassle way.its something im going to do when the bikes actualy finished and getting some use again
_________________
ive seen more tarts than mr kipling