Hey guys,

Tonight I stripped all the tape off my wiring loom.

I want to remove all the road gear from the loom.

Is there anything I shouldn't clip apart from the obvious stuff that is currently plugged in.

I know HRC do a race loom but..........$$$$$$$$...........isn't a available as time is at the mo.

A straightforward job if you are methodical. Just strip it one wire at a time, and when you get to a junction, stop!

Start at the component you wish to remove, and work back into the harness.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Ditto . I pulled my plugs and after i cut any wire i checked that the plugs still had spark and the the powervalves moved . Trace them back and there is heaps of wire to be removed .

Hey Glenn it's pretty easy even for a ham fisted Samoan like me. I just followed the excellent color wiring loom diagram . That's on the Site.

Ham fisted............HAHAHAHAHAHAHAH!!!

Sweet as team will print off a colour wiring diagram tomorrow at work.

Go team New Zealand!
_________________
After years of moaning about immigrants now i am one...

OK so the bike runs...............BUT

The Tacho doesn't work...........DOH

Anyway around untaping all the loom again to try and track down what wire I shouldn't of cut??