took my carbs off today to give them a clean and make sure they are at standard settings and the float height was set at 30mm, after reading an earlier post about carbs that recomended 12-13mm isnt this is a bit extreme .
any ideas why anyone would do that the bike did have a bodged crank when i bought it, and is 12-13 about right for a 21R
cheers all
_________________ MC21SP - Roth-tax
CBR400 - track
MC21R - sold
MC21SP - sold
just to check that i am measureing them correctly.
carbs off float chamber unscrewed, hold carbs upside down so the floats hang, and then measure to the end of the float from the flat where the float chamber screws on.
i have noticed if you set the above to 13mm it doesnt seem to open the rubber tipped valve enough. or does it
is that right or is that how you measure you "fuel" height
how do you measure your float heights _________________ MC21SP - Roth-tax
CBR400 - track
MC21R - sold
MC21SP - sold
fantastic mate, since putting the post on and going back and having another look at the one we had adjusted and the one we hadnt, we realised what we were doing wrong and you have just confirmed my stupidity
thanks again _________________ MC21SP - Roth-tax
CBR400 - track
MC21R - sold
MC21SP - sold
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum