MC28 - NC30 swinger swap

**Mon Nov 02, 2009 2:21 pm » Post: #1 » Download Post**

Anybody know if the 'wheel hub' and sproket carrier can be exchanged between s.s swingarm on an NC30/35 and an MC28?

Watfordhorn reckons that his MC28 paddock stand won't fit the NC30 swingarm fitted to his RG500. But wondered if the differences were more extensive.

**Mon Nov 02, 2009 2:30 pm » Post: #2 » Download Post**

The hub axle size is the same on them all. One paddock stand fits all.
_________________
If I have to take the carbs off once more...

**Mon Nov 02, 2009 2:37 pm » Post: #3 » Download Post**

So Stephen do you reckon I could fit the hub, rear brake and bracket on to an MC28 swingarm??

I just checked the parts manual and a few of the bits are marked KV3 and I seem to remember the NC30 rear brake mounts up differently compared to the MC28. The NC30 has a torque arm...... the NSR doesn't.

**Mon Nov 02, 2009 2:41 pm » Post: #4 » Download Post**

Its only the brake carrier that's different on a NC30. The RVF (NC35) uses the same system as the MC28.

The hub and bearing carrier are the same.

The inside dia of the axle hub is the same from NC30/35, RC30/45, MC28 etc etc.
_________________
If I have to take the carbs off once more...

**Mon Nov 02, 2009 3:14 pm » Post: #5 » Download Post**

Just checked out a few listed on eBay and they do look like they are the same........ how could I have ever doughted you Stephen Embarassed