I'm just getting one of my barrels replated, and before I order pistons do I wait until the barrel comes back before ordering the correct grade? I guess that it'll be different to the standard clearance once plated?

Had this same thing a few years back but forgotten what the outcome was..

Thanks
Paul
_________________
More **** two strokes than you can shake a **** stick at.

Er no. What you should do is order pistons first, then send them WITH the barrel and ask them to plate it to the tolerances you tell them!
_________________
MC21SP Plaything
BMW F800GS Bumblebee
Triumph 9551 Daytona Big boys toy
FJ1100 Sporting relic
GTS1000 oddball

Ah Bugger..
_________________
More **** two strokes than you can shake a **** stick at.

Yeh that`s right . I`m supprised they took it to do without pistons electrocil over here won`t touch them without the pistons

From what I remember in the past, they had the tolerances already. But that was with an rgv250 piston, when it came back I was given the grade of piston to order. I'll get in touch with them..
_________________
More **** two strokes than you can shake a **** stick at.

Don't panic..

I sent the cylinder away with one of your old pistons 2smoke, all you need to do is order the same size as you ordered last time. Can you remember what size they were?

Panic over then! I dont remember what I ordered last time but I can check with tyga I guess then order the same..!
_________________
More **** two strokes than you can shake a **** stick at.

It should state the clearance needed on the side of the piston box .

Not on OEM piston boxes it doesn't.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!