Thanks. So is i possible to machine the R spec one to match the SP specs? What are the implications of leaving the SP and R spec ones in the bottom and top barrels respectivly? _________________ Cheers,
Dave.
Allright, so i cleaned the "R" ones up a bit, result is below. The only thing remaining is the hight of the front of the valves, the SP ones seem a little taller.
A few other angles below;
Pic 2 Pic 3 _________________ Cheers,
Dave.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum