Just done a top end refresh, and trying to setup the PV's
If you follow the manual, and go by the marks then at fully open - the PV's are still at least 5mm closed and could open more. Is this right ?
Interestingly even the arrow on the servo motor doesnt tally up with the markings either.

So am i missing something or is it right that they dont open all the way ?

Cheers

The set up position is not full open, nor is the mark/hole on the power valve pully.
_________________
If I have to take the carbs off once more...

Cheers Stephen, so its right then, they remain not fully open, but i assume would fully open under real use ?

Yes, they do open fully.
If you blip the throttle you will notice that the servo pulleys move clockwise further than the markings.
_________________
2t-racelab.com

Wicked. thanks for the help.