Hi folks,
I am rebuilding by MC28SP forks. I needed a new seal on one side so decided to also install a Race Tech Gold Valve as well. I have not been able to figure out how to take apart the damper - remove the compression valve holder. I suspect there is a simple trick, but it's not clear in the parts manual or shop manual. I've included some pics below in hopes that someone can help.
_________________
MC28 SP

I thought it was just held in with a circlip?

If memory serves me correct, you just compress it, and you will see a clip (like a bit gudgeon/wrist pin circlip) in a groove in the top of the stanchion.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

.Just as you said. It is now apart. I will report back in a month or so on how well the damping kit works.