Keihin PWM and PWK

**Sun May 15, 2016 1:54 pm » Post: #1 » Download Post**

Hi Guys,

Any idea if a PWK or PWM would work on NSR250 other then pj38 and f3carbs?

**Sun May 22, 2016 1:25 am » Post: #2 » Download Post**

They should work if you get the inlet manifolds to connect them , I put Pwk powerjet carbs on my bike

**Mon May 23, 2016 12:19 pm » Post: #3 » Download Post**

They work well with the 300, but don't expect anything much with the 250, other than a probably loss of bottom-end. You may get a little over-rev, if you motor and expansion chambers are tuned to make use of it.

For the cost, you will more than likely be disappointed. They give a great induction bark though, which is fine until you get to a track day with stricter noise control! Wink

One day* I will fit my PJ38s to the MC16F3, but only for the noise! It would almost certainly run better on the F3 carbs.

*In the very dim and distant future, if I ever even start to build it!
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!