Dry Clutch

**Sun Mar 08, 2009 7:52 pm » Post: #1 » Download Post**

Hi Everyone
How tight should the bolts on the clutch hub be after replacement? Do you tighten all the way down??
CHeers

**Sun Mar 08, 2009 9:47 pm » Post: #2 » Download Post**

yeah, tighten them down to 5 nm

**Sun Mar 08, 2009 10:36 pm » Post: #3 » Download Post**

o o

Last edited by DifferentStrokes on Mon Sep 28, 2009 10:04 pm; edited 1 time in total

**Mon Mar 09, 2009 1:01 am » Post: #4 » Download Post**

10Nm as far as I'm concerned. M6 Bolt and all that. Not had one come loose, and never snapped one.

**Mon Mar 09, 2009 1:11 am » Post: #5 » Download Post**

Great Thanks heaps guy's

**Mon Mar 09, 2009 1:58 am » Post: #6 » Download Post**

I've snapped (sheered) one! Very Happy

Although it must have been flawed, as it wasn't done up particularly tight.

I've not broken a post though, but I've seen lots of bikes with broken hubs and only 4 bolts holding the pressure plate on!

They're never going to fall out though... not with the ultimate spring washer behind them! Smile

_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

**Mon Mar 09, 2009 7:02 am » Post: #7 » Download Post**

It says 5nm in the service manual Question

i checked cause i'm putting a new clutch hub and rebuild kit on tomorrow night.

**Mon Mar 09, 2009 8:12 am » Post: #8 » Download Post**

Where?

It doesn't say anything specific for them and says any unspecified M6 bolt is 10Nm.
_________________
Please do not PM me technical questions, if you can't find it on the Forum start a thread

**Mon Mar 09, 2009 9:51 am » Post: #9 » Download Post**

yeah your right, i was looking for the clutch hub nut in the service manual which is slightly mnore than 5 Nm.

It was in the bottom end rebuild tutorial of the workshop section on the main site.

Either way the threads been helpfull and i'll do them to 10nm.