So I ordered the Oil seal for the bike (the one on the shaft between the trans and 2t pump). when I got the seal i measured it, it seems the idiot ordered a 3/8 by 5/8 imperial seal which is 9.525 by 15.875. the original seal is 9.5 by 16 by 4mm. so this seal is too small on the outer diameter. I rang loads of places and the only size I could get is 9 by 16 by 4mm. So both are on my kitchen table right now. I was going to put in the 9x16x4 one tomorrow. Does anyone see any problems with this or am i being paranoid? I only want the best for my baby Also the shaft seems a little worn so a smaller inner diameter seal should be a good fit. thanks for any help guys. also I want to send off my cards to get my HRC card programmed.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum
Also the shaft seems a little worn so a smaller inner diameter seal should be a good fit. thanks for any help guys. also I want to send off my cards to get my HRC card programmed.
