Hi Mates,

I just edited the older post because i was mixing the subjects, so i decided to open a particular one for this issue, sorry for posting twice.
I was filling the tank and the gas started to poor in the floor, checking the bike i noticed that the gas came out of the filter box at the front part were there is like a nipple looking downwards. Cheking the parts diagram i see there's a tube attached and it seems to be tapped but it's not very clear. In the MC18 filter box diagram says its nº3 but i don't realize what is it.
Could you please help me?
With your permision i pasted the parts diagram for more detail.

Thanks in advance,
Cheers.
Javi

Part no. 3 is ONE tube, it's just drawn as two pieces (start and end); if you look closely, both pieces end with a jagged line where they face each other. That's how parts are sometimes drawn in technical drawings.

I am more worried about the fuel spilling out of the nipple underneath the tank. Did you overfill it?

Thanks Gepe you'are wright,

It started to spill when I poured another 5 litres to fill up the tank but i didn't top it. It didn't drip until i placed the bike vertically so maybe it's an overfill.
I'll have a closer look to the tank to check everything.
Cheers

Hi Mates,

It seems that i poured too much gas on the tank and started to flood.
Just took 2 litres of the tank and the bike does not spil gas it for now.
I was going to fit a tube like in the diagrams but i don't realice were the tube of the nipple below the tank goes.
Also i have missing the top fuel vent tube and i wanted to know were it goes aswell.
Thanks for your help guys, i'm starting to understand these bike.

Cheers

error sorry


Last edited by JaviNSR on Tue Jun 24, 2014 7:35 am; edited 1 time in total

Just finded the hose from below the tank, it was disconnected near the battery.
In the top nipple i will put a hose with a cap like in motocross bikes.