I have a weird problem.
My rc servo are on HI all the time. If i turn it to low by my hand it goes to HI when I turn key on. No difference if I pull out tps contact. But, if I kick the bike the servo goes to middle and if I give it full throttle when I kick, it goes to LO!!??

Bike is hard to run when cold. It starts with choke, but if I give it throttle it sounds like a cow and dies If i let it warm up a bit on idle and then raaarly gives it throttle "blipping the throttle" It will run. When its really warmed up its no problem. Just weak in the lower rpm.

Kind regards
Micke

Have checked my valves. Everything is fine, but my servo goes from Hi to Lo. So if i start the bike it has open valves and if i give throttle it close the valve

Has it ever run correctly? Is it the original servo?
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

This is my first 2 stroker (road bike) so I don't now if it have run perfect. But it run way better then now. Don't know if its the original servo. Can a fault tps made this problem?

I found the problem! It wasn't the bike, it was the owner!
The tips was in totally wrong position!

Make sure the TPS is set correctly, as even if its position is only slightly out, it can have a huge difference in how the bike performs.

Glad you tracked it down though.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!